Tile and LVP Floor Installation in Palm Coast, FL
We install tile and luxury vinyl plank floors in Palm Coast and check the slab for flatness, cracks and moisture first. Our own crew does the tear-out, prep and setting. Tile runs $8 to $22 per square foot installed, and most rooms take 2 to 4 days.
- Porcelain and ceramic
- Wood-look plank
- Natural stone
- Luxury vinyl plank
The floors we install in Palm Coast homes
Palm Coast Tile & Stone installs six kinds of floor in living rooms, halls, entries, kitchens and whole houses, and supplies the tile or plank for each one. The company is fully insured and has no subcontractors, so the crew that measures your floor is the crew that lays it.

Porcelain and ceramic tile floors
We recommend porcelain for most Florida floors. It soaks up 0.5 percent water or less, so it shrugs off humidity, pets and wet shoes. Sand too. Ceramic suits lighter-traffic rooms where a softer budget matters more than toughness. Bathroom floors go through our bathroom tile installation.

Wood-look plank tile
Porcelain planks that read as wood but don't swell when the air turns wet. We install them with a leveling clip system and keep the offset to a third of the plank or less, so the long edges sit flush instead of catching a toe.

Large-format tile
Tile 24 inches and up on a side, for open living areas with fewer grout lines. A big tile can't follow a dip. It rocks, then it cracks. We check the slab with a straightedge and level it first.

Natural stone floors
Travertine, marble and slate in entries, living rooms and kitchens. Stone gets full mortar coverage and a sealer. We install travertine in straight lay or the Versailles pattern. Kitchen floors and their layout go through our kitchen tile installation.

Mosaic borders and inlays
Penny-tile borders, star and medallion inlays, and pattern rugs set into a larger field of tile. We measure and dry-lay each one before it's set, so the border lands square to the room and not to a crooked wall.

Luxury vinyl plank
Rigid-core LVP for bedrooms, closets and second homes where a warmer, quieter floor matters more than tile's toughness. We test the slab for moisture first, because the plank maker sets the limit and a wet slab voids the plank warranty.

19+
Years of floors in Flagler County
- Why hire us
Why Palm Coast homeowners hire us for floors
Our owner, Jeff Herbert, is a journeyman tile setter, and he's on every floor job from the first measurement to the final walkthrough. The business has been family-owned since 2007. That's 19 years. Floors in Flagler County slab homes, from single entries to whole houses.
"We really appreciated how careful he was with the details, especially making sure everything was lined up properly."
Ivy B., Google review of a tile floor installation
No subcontractors
Our own crew tears out, preps and sets every floor.
Slab prep on every job
Our crew levels the dips and treats the cracks before any tile is mixed.
5-year workmanship warranty
If a floor we set fails because of how we laid it, we fix it at no charge.
Same-day replies and no minimum job
A single entry gets the same care as a whole house.
Floor jobs we have finished
We laid every floor below, from wood-look plank to marble mosaic. More are in our recent tile projects.

Wood-look plank going in
Brown plank tile in a kitchen walkway, with leveling clips still in the joints.

Light gray plank
Gray wood-look tile with offset joints across an empty, sunlit room.

Polished large format
Gray porcelain that runs from the hall into the kitchen without a break.

Marble-look galley kitchen
White porcelain with gold veining between the cabinets and the pantry doors.

Plank through the breakfast nook
Brown wood-look tile carried from the nook down the hallway.

Big squares by the slider
Large beige tile laid straight across a room that opens to the back.

Octagon mosaic bath
Marble octagons and gray dots across a bathroom floor.

Star inlay
A star-pattern mosaic set inside a gray border.
What our customers say about the work
Palm Coast homeowners describe our floor work on Google in their own words.
What goes under a tile floor in a Palm Coast house
Palm Coast Tile & Stone checks the slab before setting a single tile, because a tile floor is only as good as the slab under it. Most Palm Coast houses sit on a concrete slab. The table shows what we do at each layer and the standard behind it.
| Layer | What we do | The standard | What it protects |
|---|---|---|---|
| Slab flatness | Check with a straightedge, grind high spots and self-level low ones | ANSI A108.02 allows 1/8 inch in 10 feet and 1/16 inch in 24 inches under tile with an edge of 15 inches or longer | Large tile rocks or cracks over a dip |
| Slab cracks | Lay a crack isolation membrane over shrinkage cracks before tile | ANSI A118.12 rates these membranes for crack movement | A crack in the slab otherwise shows up as a crack in the tile |
| Mortar coverage | Trowel and back-butter so the mortar fills under each tile | The Ceramic Tile Education Foundation calls for 80 percent coverage on dry floors and 95 percent under natural stone | Voids sound hollow and crack where a chair leg lands |
| Movement joints | Leave a soft joint at every wall and through large or sunny rooms | TCNA EJ171 requires movement joints at the perimeter and in the field | Tile that can't move tents up or pops loose |
| Plank layout | Leveling clips in every joint and an offset of a third of the plank or less | ANSI A108.02 caps the offset at 33 percent and allows lippage of 1/32 inch plus the tile's own warpage | Long planks bow in the middle, so a half offset leaves raised edges |
Comparing estimates? Ask each installer how they check the slab and what goes over the cracks. The answer tells you more than the price does.
The tile we recommend for Florida floors
Palm Coast Tile & Stone recommends porcelain for most Palm Coast floors because it holds up to humidity, sand and wet feet better than anything else we lay. The right tile still depends on the room.
| Tile | Best rooms | Watch-out |
|---|---|---|
| Porcelain | Living areas, kitchens, entries, whole houses | Large sizes need a flat slab |
| Ceramic | Bedrooms and lighter-traffic rooms | Check the floor rating before using a wall tile underfoot |
| Wood-look plank | Living areas and halls where you want the look of wood | Needs leveling clips and a short offset |
| Large format, 24 inches and up | Open plans with fewer grout lines | The slab must be flat to the inch numbers above |
| Natural stone | Entries, living rooms, kitchens | Needs a sealer, and marble can etch |
A floor that gets walked on wet, like a kitchen or the door from the pool, should test at a wet DCOF (a slip-resistance rating) of 0.42 or higher under ANSI A137.1. Our porcelain vs ceramic tile comparison covers the two in more depth.
Tile or LVP for each room of a Florida home
Tile wins in wet rooms and high-traffic rooms, and LVP wins where you want a softer, quieter floor at a lower first cost. Plenty of houses get both. Tile goes in the kitchen, the entry and the baths, and LVP goes in the bedrooms, where nobody tracks in sand or pool water.
| Tile | Luxury vinyl plank | |
|---|---|---|
| Water and humidity | Unaffected, porcelain absorbs almost nothing | Waterproof planks, but a wet slab under them can still cause trouble |
| Sun through a slider | Holds its color and size | Can fade or move in strong direct sun, so we leave the gap the maker asks for |
| Feel underfoot | Hard and cool, welcome in a Florida summer | Softer and warmer, quieter to walk on |
| Damage | One cracked tile can be cut out and replaced | A damaged plank means unclicking a row to reach it |
| Lifespan | Decades when the slab is right | Shorter, set by the wear layer |
| Best rooms | Kitchens, entries, baths, living areas, whole houses | Bedrooms, closets, upstairs rooms, rentals |
How we install LVP on a concrete slab
LVP goes down only after the slab passes a moisture test, because the plank maker sets the moisture limit and a slab over it voids the plank warranty. Florida slabs hold moisture. We don't guess.
Palm Coast Tile & Stone tells you before any plank is opened when a slab fails, and prices the fix or a tile floor instead.

1st
Moisture test, before any plank is opened
How we run a floor job from estimate to walkthrough
A floor job runs in eight steps, and the same crew is on site from the first measurement to the last piece of trim.
1. Free estimate
We measure every room, check the slab where it shows and talk through tile or LVP with you.
2. Material order
We supply the tile or plank, the setting materials and the trim, and order extra for cuts.
3. Tear-out
Old tile, carpet or vinyl comes up, and we clear the thinset off the slab.
4. Slab prep
We grind the high spots, self-level the low ones and put membrane over the cracks.
5. Layout
We measure from the center of the room and snap lines, so cuts land at the walls and doorways.
6. Setting
We install the tile with leveling clips and full mortar coverage, or click the LVP together over the tested slab.
7. Grout and joints
Grout goes in once the mortar has cured, with soft joints at the walls and through large rooms.
8. Walkthrough
We check every room with you, fit the last transitions and go over care.
Signs we look for in Palm Coast floors built in the 2000s
Palm Coast's median home was built in 2003, and 42.5 percent of the city's houses went up between 2000 and 2009 (U.S. Census Bureau, ACS 2020-2024). Their original floor tile is now 17 to 26 years old. When we walk one of these floors, we check for six signs.
A few cracked or hollow tiles can be fixed as a tile repair. Cracks in a line across the room, or hollow spots all over, mean the floor was set wrong over the slab. That floor needs new tile.

2003
Median build year in Palm Coast
What a tile floor costs in Palm Coast
We quote tile floors at $8 to $22 per square foot installed, from standard porcelain or ceramic on a clean slab at the low end to large-format tile, natural stone or a heavily cut pattern at the top. LVP is priced by the room. We quote it at the free estimate.
Your written estimate lists tear-out, slab prep, the tile or plank, setting materials, grout, trim and transitions as separate lines, so you can see where the money goes. Our tile installation cost in Palm Coast breakdown covers other rooms too.
Tear-out and the slab
Tear-out is slow work. Removing old tile and grinding off thinset takes longer than laying new tile. A slab that needs leveling or crack membrane adds a line to the estimate.
Tile size and layout
Large-format tile and stone need more prep and careful handling. Herringbone, Versailles and diagonal layouts mean more cuts and more waste than a straight lay.
Rooms and transitions
A house cut up into small rooms, closets and doorways costs more per foot than one open room. Every transition to carpet, LVP or a slider gets its own trim.
How long a floor job takes
Setting tile is the quick part. Tear-out, slab prep and cure time fill most of the schedule, and the four typical times below show where.
We give you the schedule for your own floor in writing at the estimate, including the day the furniture can go back.

2 to 4
Days for most single rooms of tile
Where we install floors
We install tile and LVP floors in Palm Coast and the towns around it, from Beverly Beach on the coast to Daytona Beach in the south and Jacksonville in the north. Tap your town for local details, or see all our service areas.
Palm Coast, FL
Home base. We lay floors in every section of the city, from the P, B and W sections to Grand Haven.
Daytona Beach, FL
Volusia County, 30 miles down I-95, where condo and beachside floors take porcelain.
St. Augustine, FL
St. Johns County, about 30 miles north, where we've set travertine in older homes.
Floor installation questions

How much does floor tile installation cost in Palm Coast?
Tile floors run $8 to $22 per square foot installed. Where yours lands depends on how much old flooring comes up, whether the slab needs leveling or crack membrane, and the tile and layout you pick. A straight lay of standard porcelain sits at the low end, and stone or a herringbone pattern sits at the top. LVP is priced at the estimate. Call (386) 393-1166 for a free written quote.
Is tile or LVP better for a Florida home?
Tile is the better floor for kitchens, entries, baths and any room that sees water, sand or pets, and it lasts for decades. LVP suits bedrooms and quieter rooms where you want a softer, warmer floor and a lower first cost. Some houses get both. We'll walk the rooms with you and say which floor fits each one.
Can you tile over my existing tile floor?
We usually take the old tile up. Rarely worth the risk. Tiling over works only if every old tile is bonded and flat and the extra height clears the doors, the appliances and the transitions to other rooms. Most 2000s floors have a hollow tile or a crack somewhere. New tile set over a loose one fails with it. We test the old floor at the estimate.
Will cracks in my slab show through new tile?
Not when the crack gets a crack isolation membrane first. Concrete slabs shrink and crack as they cure, and tile set straight over a crack tends to crack along the same line. We install a crack isolation membrane over shrinkage cracks before tile goes down. A crack that has moved apart in height or keeps widening is a structural problem. We tell you before we set anything over it.
How do you keep wood-look plank tile flat?
We use leveling clips in every joint and keep the offset to a third of the plank or less. Long porcelain planks bow slightly in the middle, so a half offset puts the high middle of one plank next to the low end of another and leaves an edge you can feel. Clips hold the edges flush while the mortar cures. No raised edges.
How long does a new floor take, and when can I walk on it?
Most single rooms of tile take 2 to 4 days and a whole house takes 1 to 2 weeks, longer when old tile comes up or the slab needs leveling. An LVP room usually takes 1 to 3 days. You can usually walk on new tile the day after grouting, and furniture goes back once the grout has cured.
Do you supply the tile and LVP?
Yes, we supply the tile, the plank and the setting materials. You pick the look, and we order the right amount plus extra for cuts and future repairs, along with the mortar, membrane, grout and trim that suit it. One order. Nothing shows up in the wrong size or the wrong count.
Do you install hardwood floors?
No, we don't install hardwood. We install tile, natural stone and luxury vinyl plank. If you like the look of wood, wood-look porcelain plank gives you the grain without swelling in Florida humidity, and LVP gives you a softer floor for bedrooms.
Get a free floor estimate
Family-owned since 2007. Fully insured. Free estimates.
Call (386) 393-1166 or send the form, and we'll reply the same day. We book estimates Monday through Saturday, 7:00 AM to 7:00 PM.

















